Upgraded Suitcase Handle Replacement Parts for Travelers

The overall length of this item is 250mm/9.84", with a handle length of 155mm/6.1". The inner hole distance is 160mm/6.29", and the outer hole distance is 230mm/9.05". The metal mount size is 26mmx47mm/1.02x1.85" (WxL), and the hole pitch is 35mm/1.37". This handle is easy to install, as you can attach it with screws.

When choosing a handle replacement, the hole location at the end of the handle should be considered. If you can find a handle that matches the size of the hole location, the handle will fit snugly against the housing, allowing movement to grip the handle and slack between your hand and the housing.

This handle can be widely used for suitcases, luggage, soft bags, gift boxes, case carriers, and home textiles. The total length, including the end caps, is approximately 25cm/9.84 inches, and the spare handle strap length is around 15.5cm/6.10 inches. The handle width is about 2.5cm/0.98 inch.

To install the handle, carefully pull back the liner, remove the old handle, put a flat washer on each screw to keep the bolt from going through the housing, tighten the screw, and then put the liner back in.

This handle is made of zinc alloy, PVC, and steel sheet, and it is very sturdy. It is important to note that this handle only fits an inner hole distance of 160mm (6.29"), with an end hole distance of 35mm (1.37").

The package includes one suitcase handle, two metal end caps, four screw gaskets, four 10mm screws, four 16mm screws, and a screwdriver with a cross and a flat head. The handle is flexible, wear-resistant, and easy to grip.

Multiple sizes of bendable and sturdy luggage handles with ergonomic designs and strong load-bearing capacities are available, along with complete installation tools.

When choosing the size, it is recommended to first check one of the luggage handle products in the store and refer to the size chart. The most important dimensions to measure are the hole distance of the end cap and the hole distance of the inner hole.

If the received product is not the right size, it can be returned. Alternatively, you can provide the measured hole distance of the luggage handle, and the brand will recommend a suitable model.

The installation steps are as follows: 1. Confirm the hole spacing of the end cap and measure the inner hole distance. 2. Tighten the screws until all screws are in place, considering the tolerance/play before tightening. 3. Install the handle and align the screws (long and short screws are provided, or you can use old box screws if needed).

The main advantages of these luggage handles are their strong load-bearing capacity and artificial mechanical settings.

product information: